Honda Accord 9th Generation (2013-2017) check engine light comes on after oil change, why?

Honda Accord Eleventh Generation (2023-present)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

471 words

Problem Statement

Learn why the check engine light comes on after an oil change in Honda Accord 2013-2017. Step-by-step diagnostic and repair guide included.

Affected Component

Engine

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the engine to cool before opening the hood to prevent burns.

Symptoms

•Check engine light illuminated
•Engine oil level may be low or incorrect
•Possible oil leak under the vehicle
•Rough engine idle
•Unusual engine noises (ticking or knocking)

Diagnostic Steps

1
Scan the vehicle's OBD-II system for error codes using a scanner.
2
Check the oil level using the dipstick to ensure it's at the correct level.
3
Inspect for any visible oil leaks around the oil filter and drain plug.
4
Verify that the correct oil type and filter were used during the oil change.
5
Clear any error codes and monitor if the check engine light reappears after a short drive.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Oil dipstick
•Socket set
•Torque wrench

Parts Required

•Engine oil (correct viscosity and grade)
•Oil filter (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan the vehicle's OBD-II system for error codes using a scanner.
2
Check the oil level using the dipstick to ensure it's at the correct level.
3
Inspect for any visible oil leaks around the oil filter and drain plug.
4
Verify that the correct oil type and filter were used during the oil change.
5
Clear any error codes and monitor if the check engine light reappears after a short drive.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a level surface and the engine is cool.
Disconnect the negative battery terminal to prevent electrical issues.

2. Check Oil Level

Remove the dipstick and wipe it clean.
Reinsert the dipstick and remove it again to check the oil level.
If the oil is low, add the appropriate type of oil as specified in the owner’s manual.

3. Inspect for Leaks

Examine the oil filter and drain plug for tightness.
If either is loose, tighten them to the manufacturer's specified torque.
If an oil leak is found, replace the faulty oil filter or reseal the drain plug.

4. Confirm Oil Type and Filter

Verify that the oil used matches the specifications in the owner’s manual (e.g., viscosity and grade).
Ensure the oil filter is the correct part number for the vehicle model.

5. Reconnect Battery

Reconnect the negative battery terminal securely.
Ensure all tools are removed from the engine bay.