how to reset the maintenance light on Honda Accord 9th Generation (2013-2017)

Honda Accord 11th Gen (2023-Present)

Error Codes

5 minutes

Time

easy

Difficulty

low

Severity

3 min read

411 words

Problem Statement

Learn how to reset the maintenance light on a 2013-2017 Honda Accord. Step-by-step guide to ensure your vehicle's maintenance status is accurate.

Affected Component

Electrical

Estimated Time

5 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is stationary and in 'Park' mode while performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Reminder of scheduled maintenance due
•Potential confusion about the maintenance status of the vehicle

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Press and hold the 'Select/Reset' button on the instrument panel.
3
Turn the ignition switch to the 'ON' position without starting the engine.
4
Continue to hold the 'Select/Reset' button until the maintenance light resets.
5
Release the button and turn the ignition back to the 'OFF' position.
6
Start the engine to verify that the maintenance light is no longer illuminated.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required for the reset process.

Parts Required

•None required for the reset process.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Press and hold the 'Select/Reset' button on the instrument panel.
3
Turn the ignition switch to the 'ON' position without starting the engine.
4
Continue to hold the 'Select/Reset' button until the maintenance light resets.
5
Release the button and turn the ignition back to the 'OFF' position.
6
Start the engine to verify that the maintenance light is no longer illuminated.

Solution

1. Preparation

Gather necessary tools and instructions for resetting the maintenance light.
Ensure the vehicle is parked on a flat surface with the ignition turned off.

2. Perform the Reset

Locate the "Select/Reset" Button
- This button is typically found on the instrument panel, near the speedometer.
Press and Hold the Button
- Press and hold the "Select/Reset" button continuously.
Turn On the Ignition
- Without starting the engine, turn the ignition switch to the "ON" position (just before the start position).
Continue Holding the Button
- Keep holding the "Select/Reset" button until the maintenance light begins to flash and then turns off.
Release the Button
- Once the light resets, release the "Select/Reset" button.
Turn Off the Ignition
- Turn the ignition back to the "OFF" position to complete the reset process.

3. Verify the Reset

Start the engine and check that the maintenance light is no longer illuminated.