how to reset the tire pressure monitoring system on Honda Accord

Honda Accord 10th Generation (2018-2022)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

505 words

Problem Statement

Learn how to reset the tire pressure monitoring system (TPMS) on your Honda Accord. Step-by-step guide with symptoms, diagnostic steps, and tools required.

Affected Component

Electrical

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is on a stable surface to prevent rolling during the procedure.
•Always follow the manufacturer's guidelines for tire pressure.

Symptoms

•TPMS warning light illuminated on the dashboard
•Incorrect tire pressure readings displayed
•Warning message indicating low tire pressure
•Tire pressure reset button is non-responsive
•Tires have been inflated to the correct pressure but warning persists

Diagnostic Steps

1
Check the tire pressures of all tires, including the spare, using a reliable tire pressure gauge.
2
Inspect for any visible damage or leaks in the tires that may affect pressure readings.
3
Verify that the TPMS sensors are intact and not damaged.
4
Use an OBD-II scanner to check for any stored error codes related to the TPMS.
5
Confirm that the vehicle’s battery is in good condition and providing adequate voltage.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•OBD-II scanner

Parts Required

•Air compressor

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check the tire pressures of all tires, including the spare, using a reliable tire pressure gauge.
2
Inspect for any visible damage or leaks in the tires that may affect pressure readings.
3
Verify that the TPMS sensors are intact and not damaged.
4
Use an OBD-II scanner to check for any stored error codes related to the TPMS.
5
Confirm that the vehicle’s battery is in good condition and providing adequate voltage.

Solution

1. Preparation

Ensure the vehicle is parked on a flat surface with the engine off.
Gather necessary tools including an OBD-II scanner (if needed), tire pressure gauge, and the vehicle owner's manual.

2. Inflate Tires

Check and inflate all tires to the manufacturer's recommended pressure (found on the driver’s door jamb).
Do not forget to check the spare tire if applicable.

3. Reset the TPMS

Locate the TPMS reset button, usually found beneath the steering column or in the glove compartment.
Turn the ignition key to the "ON" position (do not start the engine).
Press and hold the TPMS reset button until the TPMS light blinks three times, then release the button. This usually takes about 3 seconds.

4. Start the Vehicle

Start the engine and allow it to run for a few minutes. This helps the system recognize the new tire pressures.
Turn the steering wheel from side to side to ensure the TPMS recalibrates.

5. Confirm Reset

Turn off the ignition, wait for a minute, then turn it back on to check if the TPMS light remains off.
If the light is still illuminated, repeat the reset procedure or consult a professional.