how do I reset the check engine light on my GMC Sierra T1XX (2019-Present)

GMC Sierra T1XX (2019-Present)

Error Codes

30 minutes - 1 hour

Time

medium

Difficulty

medium

Severity

2 min read

388 words

Problem Statement

Learn how to reset the check engine light on your 2019-present GMC Sierra T1XX. Step-by-step guide with diagnostic procedures and safety tips.

Affected Component

Electrical

Estimated Time

30 minutes - 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always turn off the engine and set the parking brake before working on the vehicle's electrical system.

Symptoms

•Check engine light illuminated
•Possible presence of stored error codes
•Engine running normally or exhibiting symptoms related to specific fault codes

Diagnostic Steps

1
Scan the vehicle using an OBD-II scanner to check for error codes.
2
Note any error codes displayed and their definitions.
3
Resolve any underlying issues indicated by the error codes if applicable.
4
Disconnect the negative terminal of the battery for at least 10 minutes.
5
Reconnect the negative terminal of the battery.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket wrench set

Parts Required

•None required for resetting the check engine light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan the vehicle using an OBD-II scanner to check for error codes.
2
Note any error codes displayed and their definitions.
3
Resolve any underlying issues indicated by the error codes if applicable.
4
Disconnect the negative terminal of the battery for at least 10 minutes.
5
Reconnect the negative terminal of the battery.

Solution

1. Prepare the Vehicle

Ensure the vehicle is parked on a level surface.
Turn off the engine and set the parking brake.

2. Use an OBD-II Scanner

Plug the OBD-II scanner into the diagnostic port, usually located under the dashboard near the driver's seat.
Turn the ignition key to the "ON" position without starting the engine.
Follow the scanner's prompts to read and clear the error codes.

3. Disconnect the Battery

Use a socket wrench to loosen the nut on the negative battery terminal.
Carefully remove the negative terminal from the battery post.
Wait for at least 10 minutes to allow the vehicle's systems to reset.

4. Reconnect the Battery

Reattach the negative battery terminal to the battery post.
Tighten the nut securely with the socket wrench to ensure a good connection.
Start the vehicle and check if the check engine light is off.