my Genesis G70 IG (2017-2023) key fob is not working, how do I troubleshoot it?

Genesis G70 IG (2017-2023)

Error Codes

30-60 minutes

Time

medium

Difficulty

medium

Severity

3 min read

476 words

Problem Statement

Learn how to troubleshoot and fix a non-working key fob for Genesis G70 (2017-2023). Step-by-step guide with diagnostic steps and solutions.

Affected Component

Electrical

Estimated Time

30-60 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the vehicle battery if working on electronic systems to avoid shorts.

Symptoms

•Key fob buttons unresponsive
•Vehicle does not unlock or lock when the fob is pressed
•No response when trying to start the engine with the key fob present
•Warning message displayed on the dashboard (e.g., 'Key Not Detected')
•Low battery indicator in the key fob (if applicable)

Diagnostic Steps

1
Inspect the key fob for physical damage or wear.
2
Check the battery status of the key fob and replace if necessary.
3
Test the key fob in proximity to the vehicle to determine if it is a distance issue.
4
Use a spare key fob (if available) to see if the problem persists.
5
Scan the vehicle's onboard diagnostics for any related error codes.
6
Verify that the vehicle's key fob receiver is functioning by checking for any visible damage or loose connections.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small flathead screwdriver

Parts Required

•New key fob battery (CR2032 or as specified)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the key fob for physical damage or wear.
2
Check the battery status of the key fob and replace if necessary.
3
Test the key fob in proximity to the vehicle to determine if it is a distance issue.
4
Use a spare key fob (if available) to see if the problem persists.
5
Scan the vehicle's onboard diagnostics for any related error codes.
6
Verify that the vehicle's key fob receiver is functioning by checking for any visible damage or loose connections.

Solution

1. Preparation

Gather tools and parts needed for replacement.
Ensure the vehicle is in a safe location and that all doors are closed.
Disconnect the vehicle battery if necessary for safety.

2. Replace Key Fob Battery

Tools Required: Small flathead screwdriver, new battery (CR2032 or as specified)
Sub-steps:
1. Use the small flathead screwdriver to gently pry open the key fob casing.
2. Remove the old battery carefully, noting the orientation (positive side facing up).
3. Insert the new battery in the same orientation.
4. Snap the key fob casing back together until it clicks.

3. Reprogram Key Fob (if necessary)

Tools Required: None
Sub-steps:
1. Sit in the driver's seat and close all doors.
2. Insert the key fob into the ignition and turn to the "On" position (do not start).
3. Press the "Lock" button on the key fob for 5 seconds.
4. Turn the key to the "Off" position and remove it.
5. Test the key fob functionality by locking and unlocking the doors.