why does my Genesis G70 dashboard warning lights keep flashing

Solution

1. Preparation

• Gather necessary tools and parts.
• Ensure the vehicle is parked on a level surface and the ignition is off.
• Disconnect the battery to prevent electrical shorts.

2. Check and Replace Fuses

• Locate the fuse box, typically found under the dashboard or in the engine compartment.
• Using a fuse puller or needle-nose pliers, remove any blown fuses (look for a melted wire or discoloration).
• Replace with new fuses of the same amperage rating.
• Reconnect the battery.

3. Inspect Battery and Connections

• Visually inspect the battery terminals for corrosion or loose connections.
• Clean the terminals using a wire brush and a mixture of baking soda and water if corrosion is present.
• Tighten any loose connections and ensure the battery is secure.

4. Test Alternator Output

• Reconnect the battery and start the engine.
• Use a multimeter to measure the voltage at the battery terminals (should read between 13.7 to 14.7 volts).
• If the voltage is below this range, the alternator may need to be repaired or replaced.

5. Clear Error Codes

• Use the OBD-II scanner to clear any error codes from the vehicle's system.
• Monitor the dashboard lights for any reappearance of warnings after driving.