my Genesis G70 makes a clunking noise when turning what's wrong

Genesis G70 1st Gen (2018-Present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

469 words

Problem Statement

Learn how to diagnose and fix clunking noise when turning in Genesis G70. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Always use jack stands when the vehicle is lifted to prevent accidents.

Symptoms

•Clunking noise during left or right turns
•Noise may increase with sharper turns
•Possible vibration felt through the steering wheel
•Loose or rattling sound when driving over bumps
•Vehicle pulls to one side while turning

Diagnostic Steps

1
Inspect the suspension components for wear or damage, such as control arms and bushings.
2
Check the CV joints for any signs of tearing or excessive play.
3
Examine the wheel bearings for looseness or grinding noises.
4
Test the steering components, including the tie rods and steering rack, for any issues.
5
Look for signs of loose or damaged exhaust components that may be causing noise during turns.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack
•Jack stands
•Socket set
•Torque wrench
•CV joint puller
•Grease

Parts Required

•CV joint (if damaged)
•Control arm bushings (if worn)
•Tie rod ends (if damaged)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the suspension components for wear or damage, such as control arms and bushings.
2
Check the CV joints for any signs of tearing or excessive play.
3
Examine the wheel bearings for looseness or grinding noises.
4
Test the steering components, including the tie rods and steering rack, for any issues.
5
Look for signs of loose or damaged exhaust components that may be causing noise during turns.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a level surface and the engine is turned off.
Disconnect the battery before working on electrical systems.

2. Inspect Suspension and Steering Components

Tools Required: Jack, jack stands, socket set, torque wrench.
Lift the vehicle using a jack and secure it with jack stands.
Visually inspect the control arms, bushings, and struts for wear and damage.
Check for any looseness in the tie rods and steering rack connections.

3. Replace Damaged CV Joints (if applicable)

Tools Required: Socket set, CV joint puller, grease.
Remove the wheel for access to the CV joint.
Unbolt the CV joint from the axle and steering knuckle.
Replace with a new CV joint, ensuring to pack it with grease.
Reinstall the wheel and torque to manufacturer specifications.

4. Tighten or Replace Loose Components

Tools Required: Torque wrench, socket set.
Tighten any loose bolts or nuts found during the inspection.
If any components are excessively worn, replace them with new parts.
Ensure all parts are torqued to the manufacturer's specifications.