how to fix my Genesis G70 key fob not working

Genesis G70 1st Gen (2018-Present)

Error Codes

30-60 minutes

Time

medium

Difficulty

medium

Severity

3 min read

459 words

Problem Statement

Learn how to diagnose and fix a non-working key fob for Genesis G70. Step-by-step guide with symptoms, diagnostic steps, and repair instructions.

Affected Component

Electrical

Estimated Time

30-60 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park and turned off while working on the key fob.

Symptoms

•Key fob buttons unresponsive
•Vehicle does not recognize key fob
•Warning message on the dashboard about key fob
•Inability to start the engine
•Battery drain in the vehicle if key fob is repeatedly used

Diagnostic Steps

1
Check the key fob battery by opening the fob and testing the voltage with a multimeter.
2
Inspect key fob for physical damage or corrosion on the battery contacts.
3
Verify that the vehicle's battery is fully charged and in good condition.
4
Attempt to start the vehicle using the emergency key blade if equipped.
5
Check for any error codes related to the keyless entry system using an OBD-II scanner.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small screwdriver
•Multimeter
•OBD-II scanner

Parts Required

•Key fob battery (CR2032 or as specified)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check the key fob battery by opening the fob and testing the voltage with a multimeter.
2
Inspect key fob for physical damage or corrosion on the battery contacts.
3
Verify that the vehicle's battery is fully charged and in good condition.
4
Attempt to start the vehicle using the emergency key blade if equipped.
5
Check for any error codes related to the keyless entry system using an OBD-II scanner.

Solution

1. Preparation

Gather necessary tools: small screwdriver, multimeter, new key fob battery (CR2032 or as specified in the manual).
Ensure the vehicle is parked and turned off.

2. Replace Key Fob Battery

Open the Key Fob:
- Use a small screwdriver to carefully pry open the key fob casing without damaging it.
Remove Old Battery:
- Take note of the battery orientation (positive and negative sides).
- Remove the old battery using a small flat tool if necessary.
Install New Battery:
- Place the new battery in the same orientation as the old one.
Reassemble Key Fob:
- Snap the key fob casing back together securely.

3. Reprogram Key Fob (if necessary)

Enter Programming Mode:
- Insert the key into the ignition and turn it to the "On" position without starting the engine.
Press the Lock/Unlock Button:
- Press the lock button on the key fob within 10 seconds to program it to the vehicle.
Turn Off Ignition:
- Turn the ignition back to the "Off" position to exit programming mode.