how can I tell if my Genesis G70 needs new struts?

Genesis G70 1st Gen (2018-Present)

Error Codes

3-5 hours

Time

medium

Difficulty

medium

Severity

3 min read

450 words

Problem Statement

Learn how to diagnose and replace struts on your Genesis G70. Step-by-step guide with symptoms, diagnostic steps, tools, and safety tips.

Affected Component

Suspension

Estimated Time

3-5 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always use jack stands when working under a vehicle.
•Ensure the vehicle is on a flat surface before lifting.

Symptoms

•Excessive bouncing or swaying during driving
•Vehicle feels unstable or tips during turns
•Uneven tire wear
•Loud noises when going over bumps
•Difficulty maintaining wheel alignment

Diagnostic Steps

1
Inspect the struts visually for any signs of leakage or physical damage.
2
Perform a bounce test by pushing down on each corner of the vehicle and observing how quickly it returns to its original position.
3
Check for uneven tire wear patterns that may indicate strut failure.
4
Listen for any unusual noises when driving over bumps or potholes.
5
Examine the vehicle's ride height to see if it is sagging on one side.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack and jack stands
•Socket set
•Torque wrench
•Strut spring compressor

Parts Required

•New strut assemblies
•Strut mounting hardware

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the struts visually for any signs of leakage or physical damage.
2
Perform a bounce test by pushing down on each corner of the vehicle and observing how quickly it returns to its original position.
3
Check for uneven tire wear patterns that may indicate strut failure.
4
Listen for any unusual noises when driving over bumps or potholes.
5
Examine the vehicle's ride height to see if it is sagging on one side.

Solution

1. Preparation

Gather necessary tools and parts.
Park the vehicle on a flat surface and engage the parking brake.
Disconnect the battery to ensure safety while working on the vehicle.

2. Lift the Vehicle

Use a jack to lift the vehicle and place it securely on jack stands.
Remove the wheels to access the struts.

3. Remove Old Struts

Locate the strut assembly and remove the bolts securing it to the steering knuckle.
Remove the upper mounting bolts located in the engine bay or under the rear seat, depending on the strut's location.
Carefully take out the strut assembly from the vehicle.

4. Install New Struts

Position the new strut assembly in place where the old one was removed.
Reattach the upper mounting bolts and torque them to the manufacturer’s specifications.
Secure the strut to the steering knuckle with the bolts and torque them appropriately.

5. Reassemble and Test

Reinstall the wheels and lower the vehicle back to the ground.
Reconnect the battery.
Perform a test drive to ensure proper handling and comfort.