how to reset the check engine light on Ford Explorer Sixth Generation (2020-present)?

Ford Explorer Sixth Generation (2020-present)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

429 words

Problem Statement

Learn how to reset the check engine light on a 2020-present Ford Explorer. Step-by-step guide with diagnostic procedures and tools required.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a secure position and cannot roll away while performing the reset.

Symptoms

•Check engine light illuminated
•Dashboard warning lights remain on
•Vehicle performs normally but light persists

Diagnostic Steps

1
Ensure the vehicle is in a safe and well-ventilated area.
2
Use an OBD-II scanner to check for any stored trouble codes.
3
Address any underlying issues that the codes may indicate.
4
Clear the codes using the OBD-II scanner to reset the check engine light.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and equipment.
Ensure the vehicle is off and parked on a level surface.
Have the OBD-II scanner ready.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard near the steering column.
Plug the OBD-II scanner into the port securely.
Turn the vehicle ignition to the "ON" position without starting the engine.

3. Read and Clear Codes

Follow the OBD-II scanner’s instructions to navigate to the diagnostic menu.
Select the option to “Read Codes” and take note of any trouble codes displayed.
Navigate to “Clear Codes” or “Erase Codes” option on the scanner.
Confirm the action when prompted to erase the trouble codes.

4. Disconnect OBD-II Scanner

Once the codes are cleared, safely disconnect the OBD-II scanner from the port.
Ensure no wires or tools are left in the vehicle before starting it.

5. Verify Reset

Start the vehicle and observe the dashboard to confirm the check engine light is off.