how to reset the tire pressure monitoring system in Ford Explorer Fifth Generation (2011-2019)

Ford Explorer Fifth Generation (2011-2019)

Error Codes

30 minutes

Time

medium

Difficulty

medium

Severity

3 min read

473 words

Problem Statement

Learn how to reset the tire pressure monitoring system (TPMS) in Ford Explorer (2011-2019). Step-by-step instructions and diagnostic tips included.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure that the vehicle is parked on a level surface when checking tire pressures.
•Do not attempt to reset the TPMS while driving.

Symptoms

•TPMS warning light illuminated on the dashboard
•Inaccurate tire pressure readings displayed
•Warning message on the dashboard indicating low tire pressure
•Tire pressure gauge fluctuations
•Difficulty in maintaining proper tire pressure

Diagnostic Steps

1
Check all tire pressures using a tire pressure gauge to ensure they are at the recommended levels.
2
Inspect the tires for any visible damage or leaks.
3
Verify that the TPMS sensors are functioning correctly; this may involve scanning for error codes using an OBD-II scanner.
4
Ensure the vehicle is in the correct environment (temperature and conditions) for the sensors to function properly.
5
Confirm that the battery in the TPMS sensors is not depleted (if applicable).

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•OBD-II scanner

Parts Required

•TPMS sensor batteries (if needed)
•Replacement TPMS sensors (if any are faulty)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check all tire pressures using a tire pressure gauge to ensure they are at the recommended levels.
2
Inspect the tires for any visible damage or leaks.
3
Verify that the TPMS sensors are functioning correctly; this may involve scanning for error codes using an OBD-II scanner.
4
Ensure the vehicle is in the correct environment (temperature and conditions) for the sensors to function properly.
5
Confirm that the battery in the TPMS sensors is not depleted (if applicable).

Solution

1. Preparation

Gather necessary tools: Tire pressure gauge, OBD-II scanner (if needed), and vehicle owner's manual.
Ensure that all tires are inflated to the recommended pressure stated on the driver’s door jamb label.

2. Reset the TPMS

Turn On the Ignition:
- Insert the key and turn the ignition to the "On" position without starting the engine.
Locate the Reset Button:
- Find the TPMS reset button, typically located under the steering wheel, near the brake pedal.
Press the Reset Button:
- Hold the reset button until the TPMS warning light blinks three times, then release it. This usually takes about 3 seconds.
Start the Engine:
- Start the engine and let it run for about 20 minutes to ensure the system can recalibrate.
Check the TPMS Light:
- After driving, check if the TPMS light is off. If it’s still on, repeat the reset procedure.

3. Recheck Tire Pressures

After resetting, use a tire pressure gauge to confirm that all tires are at the correct pressure. Adjust as necessary.