how to reset the tire pressure light on my Ford Explorer Fifth Generation (2011-2019)

Ford Explorer Fifth Generation (2011-2019)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

430 words

Problem Statement

Learn how to reset the tire pressure light on your Ford Explorer (2011-2019). Step-by-step guide with diagnostic steps and solutions for TPMS issues.

Affected Component

Tire Pressure Monitoring System

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is parked on a flat, stable surface while checking tire pressures.

Symptoms

•Tire pressure warning light illuminated on the dashboard
•Inconsistent tire pressure readings
•Possible rough ride due to under-inflated tires
•Check the tire pressure in multiple tires

Diagnostic Steps

1
Verify the current tire pressures using a tire pressure gauge.
2
Inspect each tire for visible damage or punctures.
3
Check the spare tire for proper inflation as it may also have a pressure sensor.
4
Use an OBD-II scanner to check for any TPMS-related error codes.
5
If applicable, confirm that the TPMS sensors are properly installed on each tire.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•Air compressor

Parts Required

•None, unless TPMS sensors require replacement.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Verify the current tire pressures using a tire pressure gauge.
2
Inspect each tire for visible damage or punctures.
3
Check the spare tire for proper inflation as it may also have a pressure sensor.
4
Use an OBD-II scanner to check for any TPMS-related error codes.
5
If applicable, confirm that the TPMS sensors are properly installed on each tire.

Solution

1. Preparation

Gather tools: Tire pressure gauge, air compressor (if needed), and vehicle owner's manual.
Ensure the vehicle is parked on a level surface and the engine is turned off.

2. Check and Adjust Tire Pressures

Sub-step 1: Remove the valve caps from each tire.
Sub-step 2: Use the tire pressure gauge to measure the air pressure in each tire.
Sub-step 3: Inflate tires to the recommended pressure as specified in the vehicle's owner manual or on the door jamb sticker.
Sub-step 4: After inflating, recheck the pressure to ensure it is correct.
Sub-step 5: Replace the valve caps securely.

3. Reset the TPMS

Sub-step 1: Turn the ignition key to the "On" position (do not start the engine).
Sub-step 2: Press the gas pedal three times within 10 seconds.
Sub-step 3: Turn the ignition off and then back on to reset the system.
Sub-step 4: Drive the vehicle for a few minutes to allow the TPMS to recalibrate.