how to reset the check engine light on Ford Explorer Fifth Generation (2011-2019)

Ford Explorer Fifth Generation (2011-2019)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

366 words

Problem Statement

Learn how to reset the check engine light on Ford Explorer (2011-2019) with this step-by-step guide. Ensure your vehicle runs smoothly after repairs.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park or neutral and the parking brake is engaged before performing any diagnostic or reset procedures.

Symptoms

•Check engine light illuminated
•Vehicle running normally after repairs
•No new error codes present after repairs

Diagnostic Steps

1
Use an OBD-II scanner to check for existing error codes.
2
Address any underlying issues causing the check engine light to illuminate.
3
Clear the error codes using the OBD-II scanner.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None (assuming no underlying issue remains after the previous repairs)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather the tools required for the process.
Ensure the vehicle is parked on a level surface and the ignition is off.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard, usually near the steering column.
Plug the OBD-II scanner into the port.
Turn the vehicle ignition to the "On" position without starting the engine.

3. Read Error Codes

Follow the prompts on the OBD-II scanner to read any stored error codes.
Note down any codes for reference if repairs are needed.

4. Clear Error Codes

Use the scanner's menu options to select "Erase Codes" or "Clear Codes."
Confirm the action when prompted by the scanner.
Wait for the scanner to indicate that codes have been cleared successfully.

5. Disconnect Scanner

Once the codes are cleared, safely disconnect the OBD-II scanner from the port.
Turn off the ignition.