How do I fix the automatic start-stop feature not working on my 2023 Chevrolet Silverado 1500 T1XX?

Chevrolet Silverado 1500 T1XX (2019-2023)

Error Codes

2-3 hours

Time

medium

Difficulty

medium

Severity

3 min read

587 words

Problem Statement

Learn how to diagnose and fix the automatic start-stop feature not working on your 2023 Chevrolet Silverado 1500 T1XX with these detailed steps.

Affected Component

automatic start-stop system

Estimated Time

2-3 hours

Symptoms

•The automatic start-stop feature does not activate when the vehicle comes to a stop.
•Dashboard light for the start-stop feature may be illuminated or flashing.
•Engine continues to run while stationary, despite the feature being enabled.

Diagnostic Steps

1
Check the Vehicle Settings
2
Inspect the Dashboard Warning Lights
3
Check Battery Health
4
Examine the Brake System
5
Inspect the Engine Control Module (ECM)

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Multimeter
•Basic hand-tools (screwdrivers, socket set)
•Torque wrench (if necessary)
•Brake cleaner (if cleaning is needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

Fixing the Automatic Start-Stop Feature Not Working on a 2023 Chevrolet Silverado 1500 T1XX

Tools Required

OBD-II scanner
Multimeter
Basic hand-tools (screwdrivers, socket set)
Torque wrench (if necessary)
Brake cleaner (if cleaning is needed)

Repair Instructions

Step 1: Check and Replace the Battery

If the battery voltage is low, consider testing it under load conditions or replace it if necessary.
- Disconnect the negative terminal first, followed by the positive terminal.
- Remove the battery hold-down bracket and lift the battery out.
- Install the new battery by reversing the removal process, ensuring terminals are tight and clean.

Step 2: Inspect and Replace the Brake Switch

If the brake switch is faulty:
- Locate the brake switch, typically mounted above the brake pedal.
- Disconnect the wiring harness.
- Remove the switch using a socket or wrench.
- Install the new brake switch and reconnect the wiring harness.

Step 3: Clear Fault Codes

After any repairs, use the OBD-II scanner to clear any fault codes.
- Connect the scanner to the OBD-II port under the dashboard.
- Follow the scanner instructions to erase the codes.

Step 4: Test the Feature

Start the vehicle and enable the automatic start-stop feature through the infotainment system.
Drive the vehicle until it comes to a complete stop, and observe if the engine shuts off as expected.

Step 5: Professional Assistance

If the above steps do not resolve the issue, it may indicate a deeper electronic or mechanical problem. It’s advisable to take the vehicle to a certified Chevrolet dealership or an experienced automotive technician for further diagnostics.

Conclusion

By following these diagnostic and repair steps, you should be able to identify and fix the automatic start-stop feature on your 2023 Chevrolet Silverado 1500 T1XX. Always remember to prioritize safety and consult a professional if you are unsure about any step in the process.