my BMW 5 Series F10/F11 (2010-2017) tire pressure light is on, how to reset it?

BMW 5 Series F10/F11 (2010-2017)

Error Codes

30 minutes

Time

medium

Difficulty

medium

Severity

3 min read

442 words

Problem Statement

The tire pressure warning light is illuminated on a BMW 5 Series F10/F11 (2010-2017), indicating a potential issue with tire pressure or a need for a reset.

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is parked safely and securely before performing any work.

Symptoms

•Tire pressure warning light illuminated on the dashboard
•Possible under-inflated tires
•Tire pressure may be uneven across tires
•Reduced fuel efficiency (if tires are significantly under-inflated)
•Abnormal tire wear patterns (if not addressed)

Diagnostic Steps

1
Verify tire pressures using a tire pressure gauge to ensure all tires are inflated to the manufacturer's recommended levels.
2
Inspect each tire visually for any signs of damage, punctures, or visible wear.
3
Check the spare tire pressure (if applicable) as some systems monitor all tires including the spare.
4
Ensure the tire pressure monitoring system (TPMS) is functioning correctly by scanning for any error codes using an OBD-II scanner.
5
Confirm that the vehicle has been driven for at least 10-15 minutes at speeds above 20 mph to allow the TPMS to calibrate.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•OBD-II scanner (optional)

Parts Required

•None (unless tires need replacement)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Verify tire pressures using a tire pressure gauge to ensure all tires are inflated to the manufacturer's recommended levels.
2
Inspect each tire visually for any signs of damage, punctures, or visible wear.
3
Check the spare tire pressure (if applicable) as some systems monitor all tires including the spare.
4
Ensure the tire pressure monitoring system (TPMS) is functioning correctly by scanning for any error codes using an OBD-II scanner.
5
Confirm that the vehicle has been driven for at least 10-15 minutes at speeds above 20 mph to allow the TPMS to calibrate.

Solution

1. Preparation

Gather necessary tools:
- Tire pressure gauge
- OBD-II scanner (if needed)
Ensure the vehicle is parked on a level surface.

2. Check and Adjust Tire Pressure

Remove valve caps from each tire.
Use the tire pressure gauge to measure the pressure in each tire.
Inflate or deflate tires to the recommended pressure as specified in the owner’s manual or on the tire placard located on the driver’s side door jamb.
Replace the valve caps securely.

3. Reset the TPMS

Turn the ignition to the "On" position without starting the engine.
Use the iDrive controller to navigate to "Vehicle Info" > "Vehicle Status" > "Tire Pressure Monitor."
Select "Reset" or "Reset Tire Pressure" and confirm.
Start the engine and drive the vehicle for a few minutes to allow the system to recalibrate.