why does my Volkswagen Tiguan First Generation (2007-2018) make a clicking noise when turning

Volkswagen Tiguan First Generation (2007-2018)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

489 words

Problem Statement

Learn how to diagnose and fix the clicking noise when turning in Volkswagen Tiguan. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always use jack stands when working under the vehicle.
•Disconnect the battery before performing any electrical work.

Symptoms

•Clicking noise during left or right turns
•Noise becomes louder with sharper turns
•Possible vibration in the steering wheel
•Decreased steering responsiveness
•Uneven tire wear

Diagnostic Steps

1
Inspect the CV joints for wear or damage.
2
Check the wheel bearings for play or noise.
3
Examine the suspension components for any loose or damaged parts.
4
Test the power steering fluid level and condition.
5
Listen for noise while moving the steering wheel from side to side with the vehicle stationary.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Lug wrench
•Jack and jack stands
•CV joint removal tool
•Socket set
•Torque wrench

Parts Required

•New CV joint (if necessary)
•New wheel bearing (if necessary)
•Replacement suspension components (if necessary)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a level surface and secured with wheel chocks.
Disconnect the battery to prevent any electrical issues.

2. Inspect and Remove the Wheel

Use a lug wrench to loosen the wheel lug nuts.
Lift the vehicle with a jack and support it with jack stands.
Remove the wheel to access the CV joint and suspension components.

3. Check CV Joints

Visually inspect the outer CV joint for torn boots or grease leakage.
If damaged, use a CV joint removal tool to detach the joint from the axle.
Replace the CV joint with a new one, ensuring proper alignment and securing it with the retaining clip.

4. Examine Wheel Bearings

Spin the wheel hub to check for roughness or noise.
If defective, remove the hub assembly using a socket set.
Replace the wheel bearing with a new unit and reassemble the hub.

5. Inspect Suspension Components

Look for any loose or damaged components like control arms, tie rods, or bushings.
Tighten any loose bolts to manufacturer specifications, or replace damaged parts as necessary.

6. Reassemble and Test

Reinstall the wheel and lug nuts, tightening them in a crisscross pattern to the correct torque specification.
Lower the vehicle from the jack stands and reconnect the battery.