how to reset the maintenance light on my Volkswagen Golf Seventh Generation (2013-2020)

Volkswagen Golf Eighth Generation (2020-present)

10-15 minutes

Time

easy

Difficulty

low

Severity

2 min read

325 words

Problem Statement

Learn how to reset the maintenance light on your Volkswagen Golf (2013-2020) with this step-by-step guide. Quick and easy instructions included.

Affected Component

Electrical

Estimated Time

10-15 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' and on a flat surface to prevent roll.

1
Ensure the vehicle is in the 'Off' position and the key is removed from the ignition.
2
Insert the key into the ignition and turn it to the 'On' position without starting the engine.
3
Press the 'Gas' pedal three times within 10 seconds.
4
Turn the ignition off and then back to the 'On' position.
5
Check if the maintenance light has turned off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'Off' position and the key is removed from the ignition.
2
Insert the key into the ignition and turn it to the 'On' position without starting the engine.
3
Press the 'Gas' pedal three times within 10 seconds.
4
Turn the ignition off and then back to the 'On' position.
5
Check if the maintenance light has turned off.

Solution

1. Preparation

2. Resetting the Maintenance Light

Turn on the Ignition:
- Insert the key into the ignition and turn it to the "On" position without starting the engine.
Press the Gas Pedal:
- Press the accelerator pedal fully three times within 10 seconds.
Turn Off the Ignition:
- Turn the ignition key to the "Off" position.
Verify Reset:
- Turn the ignition back to the "On" position and check if the maintenance light is off.