how to reset the maintenance light on my Toyota RAV4 XA40 (2013-2018)?

Toyota RAV4 XA40 (2013-2018)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

354 words

Problem Statement

Learn how to reset the maintenance light on your 2013-2018 Toyota RAV4 XA40. Step-by-step guide to ensure your vehicle's dashboard is clear.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park or neutral when performing this procedure.

Symptoms

•Maintenance light illuminated on the dashboard
•Reminder for oil change or other scheduled service displayed
•Vehicle may run smoothly after maintenance, but light remains on

Diagnostic Steps

1
Turn the ignition switch to the OFF position.
2
Press and hold the trip meter reset button on the dashboard.
3
Turn the ignition switch to the ON position without starting the engine.
4
Continue to hold the trip meter reset button until the maintenance light blinks and then turns off.
5
Release the trip meter reset button.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required for this procedure.

Parts Required

•None required for this procedure.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition switch to the OFF position.
2
Press and hold the trip meter reset button on the dashboard.
3
Turn the ignition switch to the ON position without starting the engine.
4
Continue to hold the trip meter reset button until the maintenance light blinks and then turns off.
5
Release the trip meter reset button.

Solution

1. Preparation

Ensure the vehicle is parked safely and the ignition is off.
Gather necessary items: a clean cloth (to wipe the dashboard if needed).

2. Access Trip Meter Reset Button

Locate the trip meter reset button on the instrument panel (usually near the speedometer).

3. Reset the Maintenance Light

Step 1: Turn the ignition switch to the OFF position.
Step 2: Press and hold the trip meter reset button.
Step 3: While holding the reset button, turn the ignition switch to the ON position (do not start the engine).
Step 4: Keep holding the trip meter reset button until the maintenance light blinks and then turns off (this usually takes a few seconds).
Step 5: Release the trip meter reset button.