how to reset maintenance light on Toyota RAV4 XA40 (2013-2018)

Toyota RAV4 XA40 (2013-2018)

Less than 10 minutes

Time

easy

Difficulty

low

Severity

2 min read

349 words

Problem Statement

Learn how to reset the maintenance light on a 2013-2018 Toyota RAV4 XA40 with this simple step-by-step guide. Quick and easy instructions included.

Affected Component

Electrical

Estimated Time

Less than 10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in a safe, stationary position before performing the reset.

1
Ensure the vehicle is parked and in the 'OFF' position.
2
Insert the key into the ignition without starting the engine (or press the 'Start' button twice without pressing the brake pedal).
3
Press the gas pedal three times in quick succession within five seconds.
4
Turn the ignition switch to the 'OFF' position.
5
Start the engine to verify that the maintenance light has been reset.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is parked and in the 'OFF' position.
2
Insert the key into the ignition without starting the engine (or press the 'Start' button twice without pressing the brake pedal).
3
Press the gas pedal three times in quick succession within five seconds.
4
Turn the ignition switch to the 'OFF' position.
5
Start the engine to verify that the maintenance light has been reset.

Solution

1. Preparation

2. Resetting the Maintenance Light

Access the Ignition: Insert the key into the ignition or press the "Start" button to enter the accessory mode.
Press the Gas Pedal: Quickly press the gas pedal three times within five seconds. This must be done without starting the engine.
Turn Off Ignition: Turn the ignition switch to the "OFF" position after the pedal presses.
Start the Engine: Start the engine and check the dashboard to ensure the maintenance light is off.