how to reset the maintenance light on a Toyota RAV4 Fifth Generation (2019-present)

Toyota RAV4 Fifth Generation (2019-present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

374 words

Problem Statement

Learn how to reset the maintenance light on your Toyota RAV4 Fifth Generation (2019-present) with this easy step-by-step guide.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park or neutral and the parking brake is engaged before performing the reset.

Symptoms

•Maintenance light is illuminated on the dashboard.
•Possible accompanying messages on the multi-information display regarding maintenance.
•No changes in vehicle performance or operation.

Diagnostic Steps

1
Confirm the maintenance light is active by turning the ignition on (without starting the engine).
2
Check the vehicle's maintenance schedule to determine if service is indeed due.
3
Verify any other warning lights or messages that may indicate additional issues.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required for this procedure.

Parts Required

•None required for this procedure.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked on a flat surface and the ignition is turned off.
Gather necessary tools: no specific tools are required for this reset.

2. Access the Odometer Display

Turn the ignition key to the "ON" position (do not start the engine).
Press the "Push to Start" button twice if equipped or turn the key to the "ON" position.
Ensure the odometer is displayed on the dashboard (not the trip meter).

3. Reset the Maintenance Light

Turn off the ignition again.
While holding down the "Trip" button on the dashboard, turn the ignition back to the "ON" position.
Continue to hold the "Trip" button until the maintenance light blinks and then turns off (this usually takes about 10 seconds).
Release the "Trip" button once the light has turned off.

4. Confirm Reset

Turn off the ignition one last time.
Start the engine to confirm that the maintenance light is no longer illuminated.