how to reset the maintenance light on my Toyota Highlander XU70 (2020-Present)

Toyota Highlander XU70 (2020-Present)

Error Codes

5 minutes

Time

easy

Difficulty

low

Severity

2 min read

354 words

Problem Statement

Learn how to reset the maintenance light on your 2020-present Toyota Highlander XU70 with this step-by-step guide. Quick and easy instructions included.

Affected Component

Electrical

Estimated Time

5 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a safe, stationary position before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•No other warning lights are present
•Vehicle is due for scheduled servicing

Diagnostic Steps

1
Turn the ignition key to the 'ON' position without starting the engine.
2
Ensure that the odometer is set to display the total mileage (not trip A or B).
3
Turn off the ignition.
4
Press and hold the trip reset button on the odometer.
5
While holding the trip reset button, turn the ignition back to the 'ON' position.
6
Continue holding the trip reset button until the maintenance light starts flashing and then goes off.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Vehicle key

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition key to the 'ON' position without starting the engine.
2
Ensure that the odometer is set to display the total mileage (not trip A or B).
3
Turn off the ignition.
4
Press and hold the trip reset button on the odometer.
5
While holding the trip reset button, turn the ignition back to the 'ON' position.
6
Continue holding the trip reset button until the maintenance light starts flashing and then goes off.

Solution

1. Preparation

Gather necessary tools: None required, just the vehicle key.
Ensure the vehicle is parked in a safe area.

2. Reset Maintenance Light

Turn the ignition key to the "ON" position without starting the engine.
Verify the odometer is displaying the total mileage.
Turn off the ignition completely.
Press and hold the trip reset button located on the dashboard.
While holding the trip reset button, turn the ignition back to the "ON" position without starting the engine.
Keep holding the trip reset button until the maintenance light begins to flash and then turns off (approximately 10 seconds).
Release the trip reset button.
Turn off the ignition and then start the engine to ensure the maintenance light is off.