how to replace the battery in my Toyota Highlander XU70 (2020-Present) key fob

Toyota Highlander XU70 (2020-Present)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

459 words

Problem Statement

Learn how to replace the battery in your Toyota Highlander XU70 key fob. Step-by-step guide with symptoms, diagnostic steps, and tools required.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Handle the key fob gently to avoid damaging the internal components.
•Ensure the new battery is installed correctly to avoid potential short-circuiting.

Symptoms

•Key fob not responding to button presses
•Reduced range of key fob functionality
•Warning light on dashboard indicating key fob issue
•Difficulty unlocking or locking the doors remotely
•Inability to start the vehicle using the key fob

Diagnostic Steps

1
Confirm the key fob is the only issue by trying a spare key fob if available.
2
Check for any visible damage to the key fob casing or buttons.
3
Ensure the vehicle’s battery is functional and is not causing key fob issues.
4
Test the key fob with a multimeter to check if there is any voltage output from the current battery.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Flathead screwdriver
•Small Phillips screwdriver

Parts Required

•CR2032 battery

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Confirm the key fob is the only issue by trying a spare key fob if available.
2
Check for any visible damage to the key fob casing or buttons.
3
Ensure the vehicle’s battery is functional and is not causing key fob issues.
4
Test the key fob with a multimeter to check if there is any voltage output from the current battery.

Solution

1. Preparation

Gather necessary tools and parts.
Tools Required: Flathead screwdriver, small Phillips screwdriver.
Parts Required: CR2032 battery (or appropriate battery type as specified in the owner’s manual).

2. Open the Key Fob

Sub-step 1: Locate the seam on the side of the key fob.
Sub-step 2: Use a flathead screwdriver to gently pry open the key fob at the seam, taking care not to damage the casing.
Sub-step 3: Once opened, carefully separate the two halves of the key fob.

3. Replace the Battery

Sub-step 1: Remove the old battery by gently lifting it out of its compartment using the screwdriver if necessary.
Sub-step 2: Note the orientation of the battery (positive side facing up or down).
Sub-step 3: Insert the new CR2032 battery in the same orientation as the old battery.

4. Reassemble the Key Fob

Sub-step 1: Align the two halves of the key fob together.
Sub-step 2: Press the halves together until they click securely.
Sub-step 3: Test the key fob to ensure it is functioning properly.