how to reset the tire pressure light on Toyota Highlander Third Generation (2014-2019)?

Toyota Highlander Third Generation (2014-2019)

Error Codes

30 minutes

Time

medium

Difficulty

medium

Severity

3 min read

459 words

Problem Statement

Learn how to reset the tire pressure light on your 2014-2019 Toyota Highlander. Step-by-step guide with diagnostic steps and safety tips.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is parked on a level surface when checking tire pressures.
•Always wear safety glasses when working with tires to protect against debris.

Symptoms

•Tire pressure warning light illuminated on the dashboard
•Possible uneven tire wear
•Reduced fuel efficiency
•Decreased handling stability
•Tire pressures may be low or inflated

Diagnostic Steps

1
Confirm that all tires, including the spare, are inflated to the recommended pressure as specified on the driver's side door jamb.
2
Drive the vehicle at a speed of at least 25 mph for about 10 minutes to allow the system to recalibrate.
3
Check for any visible damage or leaks in the tires that may contribute to pressure loss.
4
Use an OBD-II scanner to check for any TPMS-related error codes if the light remains illuminated after adjustments.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•Air compressor

Parts Required

•TPMS sensors (if replacement is needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Confirm that all tires, including the spare, are inflated to the recommended pressure as specified on the driver's side door jamb.
2
Drive the vehicle at a speed of at least 25 mph for about 10 minutes to allow the system to recalibrate.
3
Check for any visible damage or leaks in the tires that may contribute to pressure loss.
4
Use an OBD-II scanner to check for any TPMS-related error codes if the light remains illuminated after adjustments.

Solution

1. Preparation

Gather the required tools: an air compressor or tire pressure gauge.
Ensure all tires are properly inflated to the recommended pressure (found on the placard inside the driver’s door).

2. Resetting the TPMS

Turn on the Ignition:
- Insert the key and turn the ignition to the "ON" position without starting the engine.
Locate the TPMS Reset Button:
- The TPMS reset button is typically located below the steering column or near the left side of the dashboard.
Press and Hold the TPMS Reset Button:
- Press and hold the button until the tire pressure light blinks three times, then release the button.
Turn Off the Ignition:
- Turn the ignition off and then start the vehicle. The TPMS light should be off, indicating a successful reset.

3. Final Check

After resetting, recheck the tire pressures once the vehicle is running to ensure they remain at the recommended levels.