how to reset the maintenance light on Toyota Corolla E210 (2019-2024)

Toyota Corolla E210 (2019-2024)

10 minutes

Time

easy

Difficulty

low

Severity

2 min read

319 words

Problem Statement

Learn how to reset the maintenance light on a 2019-2024 Toyota Corolla E210. Step-by-step guide to clear reminders after maintenance.

Affected Component

Electrical

Estimated Time

10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in a safe and stable position before performing the reset.

1
Ensure the vehicle is in the 'ON' position without starting the engine.
2
Verify that the maintenance service has been completed (oil change, filter replacement, etc.).
3
Check the vehicle's odometer to confirm that it is displaying the current mileage.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Solution

1. Preparation

2. Access the Maintenance Reset Mode

Turn the ignition to the "ON" position (do not start the engine).
On the dashboard, locate the trip meter reset button (usually on the instrument cluster).
Press and hold the trip meter reset button.

3. Reset the Maintenance Light

While holding the trip meter reset button, turn the ignition off and then back to the "ON" position (without starting the engine).
Continue holding the trip meter reset button until the maintenance light flashes and then turns off.
Release the button after the light goes out.