why does my Toyota Corolla E170 (2013-2019) make a clunking noise when turning?

Toyota Corolla E170 (2013-2019)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

543 words

Problem Statement

Learn how to diagnose and fix clunking noise when turning in Toyota Corolla E170 (2013-2019). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always disconnect the battery before working on electrical components.
•Ensure the vehicle is securely lifted and supported with jack stands before working underneath it.

Symptoms

•Clunking noise when turning left or right
•Noise increases with sharper turns
•Possible vibration felt in the steering wheel
•Reduced handling stability
•Knocking sound when driving over bumps

Diagnostic Steps

1
Inspect the front suspension components for wear or damage.
2
Check the CV joints and boots for any signs of tears or leaks.
3
Lift the vehicle and check for play in the wheel bearings.
4
Examine the struts and shocks for leaks or damage.
5
Test for loose or damaged engine or transmission mounts.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack and jack stands
•Socket set
•Torque wrench
•Pry bar
•Inspection mirror

Parts Required

•Control arms (if damaged)
•Ball joints (if worn)
•CV joint or axle assembly (if defective)
•Struts or shocks (if leaking or worn)
•Engine or transmission mounts (if damaged)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather tools and parts required.
Park the vehicle on a level surface and engage the parking brake.
Lift the front of the vehicle using a jack and secure it with jack stands.

Tools Required:

Jack and jack stands
Socket set
Torque wrench
Pry bar
Inspection mirror

2. Inspect Suspension Components

Sub-step 1: Visually inspect the control arms, bushings, and ball joints for any signs of wear or damage.
Sub-step 2: Use a pry bar to check for excessive play in the bushings and joints.
Sub-step 3: Replace any worn or damaged components as necessary.

3. Check CV Joints and Boots

Sub-step 1: Inspect the CV boots for tears or grease leaks.
Sub-step 2: Rotate the wheels by hand and listen for clicking or popping noises indicating a bad CV joint.
Sub-step 3: Replace the CV joint or axle assembly if damage is found.

4. Examine Struts and Shocks

Sub-step 1: Check for fluid leaks on the struts and shocks.
Sub-step 2: Push down on the front of the vehicle to check for excessive bounce, indicating worn shocks.
Sub-step 3: Replace any faulty struts or shocks.

5. Verify Engine and Transmission Mounts

Sub-step 1: Inspect the engine and transmission mounts for cracks or separation.
Sub-step 2: Check for excessive movement of the engine during acceleration and deceleration.
Sub-step 3: Replace any damaged mounts to ensure proper alignment and reduce noise.