how to reset the tire pressure light on Toyota Camry XV70 (2018-2024)?

Toyota Camry XV80 (2025-Present)

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

441 words

Problem Statement

Learn how to reset the tire pressure light on a 2018-2024 Toyota Camry XV70. Step-by-step guide to ensure proper tire pressure and system reset.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

1
Check the tire pressure of all four tires using a tire pressure gauge.
2
Inflate or deflate the tires to the manufacturer's recommended pressure (usually found on the driver's side door jamb).
3
Inspect the spare tire (if equipped) for proper pressure, as some systems monitor the spare.
4
Verify that the tire pressure monitoring system (TPMS) sensors are functioning correctly.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Check the tire pressure of all four tires using a tire pressure gauge.
2
Inflate or deflate the tires to the manufacturer's recommended pressure (usually found on the driver's side door jamb).
3
Inspect the spare tire (if equipped) for proper pressure, as some systems monitor the spare.
4
Verify that the tire pressure monitoring system (TPMS) sensors are functioning correctly.

Solution

1. Preparation

Ensure that all tires, including the spare, are inflated to the correct pressure.
Gather necessary tools: tire pressure gauge, air compressor (if needed).

2. Resetting the Tire Pressure Light

Turn on the Ignition
- Without starting the engine, turn the ignition key to the "ON" position or press the "Start" button twice without pressing the brake pedal.
Locate the TPMS Reset Button
- The TPMS reset button is usually located under the steering wheel or near the driver's side door. Refer to the owner's manual for the exact location.
Press and Hold the TPMS Reset Button
- Press and hold the reset button until the tire pressure light blinks three times, then release the button.
Turn Off the Ignition
- Turn the ignition off and wait for about 20 seconds.
Start the Engine
- Start the engine and check if the tire pressure light is off. If the light remains on, ensure all tires are correctly inflated and repeat the reset process.