how to reset the maintenance light on my Toyota Camry XV40 (2007-2011)

Toyota Camry XV80 (2025-Present)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

363 words

Problem Statement

Learn how to reset the maintenance light on your 2007-2011 Toyota Camry XV40 with this step-by-step guide. Quick and easy instructions included.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

1
Ensure the vehicle is in the 'ON' position without starting the engine.
2
Confirm that the odometer is set to display total mileage (not trip A or trip B).
3
Turn off the ignition.
4
Press and hold the 'Trip' button on the odometer.
5
While holding the 'Trip' button, turn the ignition back to the 'ON' position.
6
Continue to hold the 'Trip' button until the maintenance light flashes and then turns off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'ON' position without starting the engine.
2
Confirm that the odometer is set to display total mileage (not trip A or trip B).
3
Turn off the ignition.
4
Press and hold the 'Trip' button on the odometer.
5
While holding the 'Trip' button, turn the ignition back to the 'ON' position.
6
Continue to hold the 'Trip' button until the maintenance light flashes and then turns off.

Solution

1. Preparation

2. Reset the Maintenance Light

Set Odometer: Confirm that the odometer displays the total mileage.
Turn Off Ignition: Switch off the ignition completely.
Press and Hold Trip Button: While holding the "Trip" button, keep it pressed.
Ignition On: Turn the ignition key to the "ON" position (do not start the engine).
Watch for Light: Continue holding the "Trip" button. The maintenance light will flash and should eventually turn off.
Release the Button: Once the light is off, release the "Trip" button.