how to reset the maintenance light on Toyota Camry XV50 (2012-2017)

Toyota Camry XV70 (2018-2024)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

393 words

Problem Statement

Learn how to reset the maintenance light on Toyota Camry XV50 (2012-2017) with this step-by-step guide. Quick and easy instructions for a successful reset.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is parked safely and the engine is off before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Vehicle may signal the need for an oil change or other routine service

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the key is removed from the ignition.
2
Insert the key into the ignition and turn it to the 'ON' position without starting the engine.
3
Check if the odometer is set to display the trip meter (Trip A).
4
If the trip meter is not displaying, press the trip meter reset button until 'Trip A' is shown.
5
Turn the ignition off again and then back to the 'ON' position while still holding the trip meter reset button.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Vehicle key

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the key is removed from the ignition.
2
Insert the key into the ignition and turn it to the 'ON' position without starting the engine.
3
Check if the odometer is set to display the trip meter (Trip A).
4
If the trip meter is not displaying, press the trip meter reset button until 'Trip A' is shown.
5
Turn the ignition off again and then back to the 'ON' position while still holding the trip meter reset button.

Solution

1. Preparation

Ensure the vehicle is parked on a flat surface.
Have the vehicle key ready to access the ignition.

2. Turn On Ignition

Insert the key into the ignition.
Turn the key to the "ON" position without starting the engine.

3. Set Odometer to Trip A

Locate the trip meter reset button on the dashboard.
Press the button until the display shows "Trip A."

4. Reset Maintenance Light

With the ignition still in the "ON" position, press and hold the trip meter reset button.
While holding the button, turn the ignition off and then back to the "ON" position.
Continue to hold the trip meter reset button until the maintenance light begins to blink and then turns off.

5. Finalize

Release the trip meter reset button.
Turn the ignition off and then start the engine to ensure the maintenance light is no longer illuminated.