how to reset the maintenance light on my Toyota Camry XV50 (2012-2017)

Toyota Camry XV70 (2018-2024)

5-10 minutes

Time

easy

Difficulty

low

Severity

3 min read

404 words

Problem Statement

Learn how to reset the maintenance light on your 2012-2017 Toyota Camry XV50 after an oil change. Step-by-step guide for easy maintenance.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in park and on a level surface before performing any resets.

1
Ensure the vehicle is parked on a level surface and the ignition is turned off.
2
Press the odometer reset button located on the instrument panel.
3
Turn the ignition switch to the 'ON' position without starting the engine.
4
Continue to hold the odometer reset button until the maintenance light flashes and then turns off.
5
Release the odometer reset button and turn off the ignition.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is parked on a level surface and the ignition is turned off.
2
Press the odometer reset button located on the instrument panel.
3
Turn the ignition switch to the 'ON' position without starting the engine.
4
Continue to hold the odometer reset button until the maintenance light flashes and then turns off.
5
Release the odometer reset button and turn off the ignition.

Solution

1. Preparation

2. Reset Maintenance Light

Locate the Odometer Reset Button
- This button is typically found on the instrument panel near the speedometer.
Turn Off the Ignition
- Ensure the car is completely turned off before proceeding.
Press and Hold the Odometer Reset Button
- Press the button and hold it down.
Turn the Ignition to "ON" Position
- Without starting the engine, turn the key to the "ON" position. The dashboard lights should illuminate.
Wait for the Maintenance Light to Flash
- Continue holding the odometer reset button until the maintenance light flashes and then turns off (this may take a few seconds).
Release the Odometer Reset Button
- Once the light is off, you can release the button.
Turn Off the Ignition
- Turn the ignition back to the "OFF" position to complete the reset process.