how to change the oil in my Toyota Camry Eighth Generation (2018-present)

Toyota Camry Eighth Generation (2018-present)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

561 words

Problem Statement

Learn how to change the oil in your Toyota Camry (2018-present) with this step-by-step guide. Ensure optimal engine performance and longevity.

Affected Component

Engine

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Allow engine to cool before opening the oil filler cap or drain plug.
•Use caution while working under the vehicle; ensure it is securely lifted if necessary.

Symptoms

•Engine oil is dirty or discolored
•Engine oil level is low
•Engine noise increases due to insufficient lubrication
•Engine warning light illuminated
•Decreased fuel efficiency

Diagnostic Steps

1
Check the engine oil level using the dipstick to determine if it is low or dirty.
2
Inspect the oil filter for any leaks or signs of wear.
3
Look for any oil leaks under the vehicle or around the engine area.
4
Verify the oil change interval based on the owner's manual recommendations.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Oil filter wrench
•Drain pan
•Funnel
•Torque wrench
•Rags or paper towels

Parts Required

•Engine oil (5W-20 or as specified in the owner's manual)
•Oil filter (specific to 2018-present Camry)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather all necessary tools and parts.
Ensure the vehicle is parked on a level surface and turn off the engine.
Allow the engine to cool down for at least 30 minutes to prevent burns.

2. Gather Tools and Parts

Tools Required:
- Socket set
- Oil filter wrench
- Drain pan
- Funnel
- Torque wrench
- Rags or paper towels
Parts Required:
- Engine oil (5W-20 or as specified in the owner's manual)
- Oil filter (specific to 2018-present Camry)

3. Drain Old Oil

1. Place the drain pan under the oil pan.
2. Remove the oil drain plug using the appropriate socket.
3. Allow the old oil to drain completely into the pan.
4. Replace the drain plug and tighten it to the manufacturer's torque specifications (typically around 30 ft-lbs).

4. Replace Oil Filter

1. Use the oil filter wrench to remove the old oil filter.
2. Apply a thin layer of new oil to the rubber gasket of the new oil filter.
3. Install the new oil filter by hand-tightening it until secure (do not overtighten).

5. Add New Oil

1. Open the hood and remove the oil filler cap.
2. Using a funnel, pour the new engine oil into the engine.
3. Check the oil level with the dipstick, adding more oil if necessary to reach the correct level.

6. Final Checks

1. Start the engine and let it run for a few minutes, checking for leaks around the oil filter and drain plug.
2. Turn off the engine and recheck the oil level, adding more oil if needed.