why does my Tesla Model Y Current (2020-present) make a clicking noise when turning

Tesla Model Y Current (2020-present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

478 words

Problem Statement

Learn how to diagnose and fix clicking noise when turning in Tesla Model Y. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Ensure the vehicle is securely supported on jack stands before working underneath.

Symptoms

•Clicking noise during left or right turns
•Noise increases with speed while turning
•Vibration felt in the steering wheel
•Possible grinding noise if the issue worsens
•No warning lights illuminated on the dashboard

Diagnostic Steps

1
Inspect the front suspension components for wear or damage.
2
Check the CV (Constant Velocity) joints for signs of wear or damage.
3
Lift the vehicle and spin the wheels to listen for abnormal noises.
4
Examine the wheel bearings for play or roughness.
5
Perform a visual inspection of the brake components for any interference.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Torque wrench
•CV joint puller
•Bearing puller
•Jack and jack stands

Parts Required

•New CV joint (if required)
•New wheel bearing (if required)
•New brake pads (if worn during inspection)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the front suspension components for wear or damage.
2
Check the CV (Constant Velocity) joints for signs of wear or damage.
3
Lift the vehicle and spin the wheels to listen for abnormal noises.
4
Examine the wheel bearings for play or roughness.
5
Perform a visual inspection of the brake components for any interference.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is on a level surface and securely lifted (use jack stands).
Disconnect the battery to avoid electrical issues during repairs.

2. Inspect and Replace CV Joints

Sub-steps:
1. Remove the front wheels using a socket set.
2. Locate the CV joints on both sides of the vehicle.
3. Check the rubber boots for tears or leaks. If damaged, replace the CV joint:
  - Use a CV joint puller to detach the joint from the axle.
  - Clean the area and install a new CV joint, ensuring the boot is secure.
  - Reattach the axle to the wheel hub and torque to manufacturer specifications (usually around 80-95 ft-lbs).

3. Inspect and Replace Wheel Bearings

Sub-steps:
1. Remove the brake caliper and rotor to access the wheel bearing (use a torque wrench to avoid damaging components).
2. Inspect the wheel bearing for play by moving the wheel back and forth.
3. If the bearing feels rough or has excessive play, replace it:
  - Use a bearing puller to remove the old bearing.
  - Install the new bearing and ensure it is properly seated.
  - Reassemble the brake rotor and caliper, ensuring proper torque values are met.