how to reset the check engine light in Tesla Outback 5th Generation (2015-2019)

Subaru Outback 5th Generation (2015-2019)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

449 words

Problem Statement

Learn how to reset the check engine light in a 2015-2019 Subaru Outback. Step-by-step guide with diagnostic procedures and safety tips.

Affected Component

Engine

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' with the parking brake engaged before starting the reset process.

Symptoms

•Check engine light illuminated
•Potential reduction in engine performance
•Possible increased fuel consumption
•No noticeable changes in driving experience (if the issue was minor)
•Error codes stored in the vehicle's computer system

Diagnostic Steps

1
Use an OBD-II scanner to check for stored error codes.
2
Record the error codes to determine if they indicate a specific issue.
3
Address the underlying problem that triggered the check engine light (if applicable).
4
Confirm that the vehicle is in a safe condition to reset the light.
5
Connect the OBD-II scanner to the vehicle's diagnostic port.
6
Use the scanner's function to clear the codes.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None required for the reset but may need repairs based on diagnostic codes.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Use an OBD-II scanner to check for stored error codes.
2
Record the error codes to determine if they indicate a specific issue.
3
Address the underlying problem that triggered the check engine light (if applicable).
4
Confirm that the vehicle is in a safe condition to reset the light.
5
Connect the OBD-II scanner to the vehicle's diagnostic port.
6
Use the scanner's function to clear the codes.

Solution

1. Preparation

Ensure the vehicle is parked on a level surface and is turned off.
Gather necessary tools (OBD-II scanner).
Ensure the vehicle’s battery is in good condition.

2. Diagnose and Address Issues

If error codes were retrieved, research or consult repair manuals to address any underlying issues.
Repair or replace any components that are malfunctioning based on the diagnostic codes.

3. Reset the Check Engine Light

Connect OBD-II Scanner
- Locate the OBD-II port, usually found beneath the dashboard near the steering column.
- Plug in the OBD-II scanner.
Turn on Ignition
- Turn the vehicle's ignition to the "ON" position without starting the engine.
Access Scanner Functions
- Navigate through the scanner's menu to find the "Erase Codes" or "Clear Codes" option.
- Select this option to clear the check engine light.
Confirmation
- Wait for a confirmation message that the codes have been cleared. Disconnect the scanner.
Test Drive
- Start the vehicle and take it for a short drive to ensure the check engine light does not reappear.