how to replace the battery in my Tesla Outback key fob?

Subaru Outback 4th Generation (2010-2014)

Error Codes

15-30 minutes

Time

easy

Difficulty

low

Severity

3 min read

464 words

Problem Statement

Learn how to replace the battery in your Tesla Outback key fob. Step-by-step instructions for diagnosing issues and performing the replacement.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Be cautious when using tools to avoid damaging the key fob.

Symptoms

•Key fob not responding when buttons are pressed
•Range of the key fob significantly reduced
•Warning message on the vehicle's display indicating low key fob battery
•Inability to unlock or start the vehicle using the key fob

Diagnostic Steps

1
Confirm that the key fob is the issue by trying to unlock the vehicle using the physical key or another working fob.
2
Inspect the key fob for physical damage or corrosion.
3
Check for any error messages or notifications regarding the key fob on the vehicle's display.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small flathead screwdriver
•Coin

Parts Required

•CR2032 battery

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather the necessary tools and components.
Ensure the vehicle is parked in a safe area.
Wear safety glasses to protect your eyes.

2. Open the Key Fob

Tools Required: Small flathead screwdriver or a coin.
Locate the seam on the edge of the key fob.
Carefully insert the flathead screwdriver or coin into the seam and twist slightly to pop open the key fob casing.

3. Remove the Old Battery

Identify the battery type (usually CR2032 for most key fobs).
Gently lift the old battery out of its compartment using a plastic tool or your fingers, ensuring not to damage any contacts.

4. Install the New Battery

Parts Required: CR2032 battery (or specific battery type for your model).
Insert the new battery into the compartment, ensuring the positive (+) side is facing up.
Press down gently to secure the battery in place.

5. Reassemble the Key Fob

Align the two halves of the key fob casing.
Press them together firmly until you hear a click, indicating the fob is sealed properly.

6. Test the Key Fob

Stand a few feet away from the vehicle and press any button on the key fob.
Confirm that the vehicle responds by unlocking or starting.