how to reset check engine light Ram 1500 DT (2019-Present)

Ram 1500 DT (2019-Present)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

374 words

Problem Statement

Learn how to reset the check engine light on your 2019-present Ram 1500 DT after repairs. Step-by-step guide with diagnostic steps and tools required.

Affected Component

Engine

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park and the parking brake is engaged before performing any work.

Symptoms

•Check engine light illuminated
•Engine running smoothly after repairs
•No new error codes present
•Previous issues have been resolved

Diagnostic Steps

1
Use an OBD-II scanner to check for any stored error codes.
2
Document any error codes and clear them using the scanner.
3
Verify that the repairs related to the error codes were completed.
4
Start the engine and observe the check engine light status.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None (assuming previous issues have been resolved)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required: OBD-II scanner
Ensure the vehicle is parked on a level surface and the engine is off.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard, typically near the driver's side.
Plug in the OBD-II scanner and turn the ignition to the "ON" position without starting the engine.

3. Read and Clear Codes

Follow the scanner's prompts to access the diagnostic menu.
Select the option to read error codes and note any that are present.
Choose the option to clear or reset the codes.
Confirm the action when prompted by the scanner.

4. Turn Off Ignition

After clearing the codes, turn off the ignition and unplug the OBD-II scanner.

5. Start the Engine

Start the engine and ensure the check engine light remains off.
Allow the vehicle to idle for a few minutes to verify that no new codes appear.