how to change the oil in my Honda Civic 10th Generation (2016-2021)

Honda Civic 11th Generation (2022-Present)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

555 words

Problem Statement

Step-by-step guide on how to change the oil in a 10th Generation Honda Civic (2016-2021). Learn symptoms, diagnostic steps, and required tools.

Affected Component

Engine

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the engine is cool before starting.
•Dispose of old oil and filter properly at a designated recycling center.

Symptoms

•Engine oil change indicator light illuminated
•Engine making unusual noises
•Engine overheating
•Decreased fuel efficiency
•Presence of oil spots underneath the vehicle

Diagnostic Steps

1
Verify the current oil level using the dipstick.
2
Check the owner's manual for the recommended oil type and capacity.
3
Inspect the oil filter for any leaks or damage.
4
Examine the undercarriage for signs of oil leaks.
5
Confirm that the engine is cool before starting the oil change process.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Oil filter wrench
•Socket set
•Oil catch pan
•Funnel
•Rags or paper towels

Parts Required

•New oil filter
•New engine oil (5W-20)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather Tools and Materials:
- Oil filter wrench
- Socket set (usually 17mm for the drain plug)
- Oil catch pan
- Funnel
- New oil filter
- New engine oil (5W-20 or as specified in the owner's manual)
- Rags or paper towels
Safety Warning: Ensure the engine is completely cool to avoid burns. Park the vehicle on a flat surface and engage the parking brake.

2. Drain Old Oil

Place the oil catch pan under the oil pan.
Using the socket set, remove the drain plug (turn counterclockwise).
Allow the old oil to drain completely into the pan. This may take several minutes.

3. Replace Oil Filter

Use the oil filter wrench to loosen and remove the old oil filter.
Before installing the new filter, apply a small amount of new oil to the rubber gasket of the new filter to ensure a good seal.
Install the new oil filter by hand, tightening it until snug (do not overtighten).

4. Add New Oil

Replace the drain plug and tighten it securely (typically around 30 lb-ft torque).
Using a funnel, pour the new engine oil into the engine through the oil filler cap. Refer to the owner's manual for the correct oil capacity (usually around 4.4 quarts).
Replace the oil filler cap securely.

5. Check Oil Level

Start the engine and let it run for a few minutes, then turn it off.
Wait a few minutes, then check the oil level using the dipstick. Add more oil if necessary until it reaches the proper level.