how to change oil in Honda Civic 10th Generation (2016-2021)

Honda Civic 10th Generation (2016-2021)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

567 words

Problem Statement

Step-by-step guide on how to change the engine oil in a Honda Civic 10th Generation (2016-2021). Includes symptoms, diagnostic steps, and tools required.

Affected Component

Engine

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Allow the engine to cool before starting the oil change.
•Ensure the vehicle is parked on a level surface to avoid spills.

Symptoms

•Engine oil is dirty or discolored
•Engine oil change light illuminated
•Excessive engine noise
•Decreased fuel efficiency
•Visible oil leaks under the vehicle

Diagnostic Steps

1
Gather necessary tools and parts for the oil change.
2
Check the engine oil level using the dipstick to confirm the need for an oil change.
3
Inspect the oil filter for signs of wear or leaks.
4
Verify the type of engine oil recommended for the specific Honda Civic model.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Oil filter wrench
•Socket set
•Oil drain pan
•Funnel
•Torque wrench
•Rags or paper towels

Parts Required

•New engine oil (5W-20 or as specified in the owner’s manual)
•New oil filter

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required:
- Oil filter wrench
- Socket set
- Oil drain pan
- Funnel
- Torque wrench
- Rags or paper towels
Parts Required:
- New engine oil (5W-20 or as specified in the owner’s manual)
- New oil filter
Park the vehicle on a level surface and ensure the engine is cool.
Gather all tools and parts before starting.

2. Drain Old Oil

Place the oil drain pan under the oil pan.
Remove the engine oil fill cap to allow oil to drain more freely.
Using a socket wrench, remove the oil drain bolt (ensure it is not hot).
Allow the old oil to completely drain into the pan.

3. Replace Oil Filter

Use the oil filter wrench to remove the old oil filter.
Apply a small amount of new oil to the rubber gasket of the new oil filter.
Install the new oil filter by hand, turning until snug (do not over-tighten).

4. Add New Oil

Reinstall the oil drain bolt and torque it to the manufacturer’s specifications (typically around 30 ft-lbs).
Use a funnel to pour the new engine oil into the engine through the oil fill cap.
Start with approximately 4.5 quarts of oil and check the dipstick to ensure proper level.

5. Check for Leaks and Final Steps

Start the engine and let it run for a few minutes, checking for leaks around the oil filter and drain plug.
Turn off the engine and wait a minute, then recheck the oil level with the dipstick.
Add more oil if necessary to reach the correct level.