how to reset the maintenance light in my Honda Accord 10th Generation (2018-2022)

Honda Accord 8th Generation (2008-2012)

Less than 10 minutes

Time

easy

Difficulty

low

Severity

2 min read

359 words

Problem Statement

Learn how to reset the maintenance light on your Honda Accord 10th Generation (2018-2022) with this easy step-by-step guide.

Affected Component

Electrical

Estimated Time

Less than 10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in a safe, stationary position before performing the reset.

1
Turn the ignition off and ensure the vehicle is in the 'OFF' position.
2
Hold down the select/reset button on the instrument panel.
3
Turn the ignition to the 'ON' position without starting the engine while continuing to hold the select/reset button.
4
Wait for the maintenance light to blink and then go out, indicating that it has been reset.
5
Release the select/reset button.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Turn the ignition off and ensure the vehicle is in the 'OFF' position.
2
Hold down the select/reset button on the instrument panel.
3
Turn the ignition to the 'ON' position without starting the engine while continuing to hold the select/reset button.
4
Wait for the maintenance light to blink and then go out, indicating that it has been reset.
5
Release the select/reset button.

Solution

1. Preparation

2. Reset Maintenance Light

Turn Off Ignition: Ensure the ignition is off.
Hold Select/Reset Button: Locate the select/reset button on the instrument cluster and press and hold it.
Turn Ignition On: With the button still held, turn the ignition to the "ON" position (do not start the engine).
Wait for Light to Reset: Observe the maintenance light; it will blink and then turn off after a few seconds.
Release Button: Release the select/reset button once the light goes off.