how to reset the EPS warning light on Honda Accord 9th Generation (2013-2017)

Honda Accord Eleventh Generation (2023-present)

Error Codes

1-2 hours

Time

medium

Difficulty

high

Severity

3 min read

452 words

⚠️ Safety Warning

This issue requires immediate attention. If you are not experienced with automotive repairs, consult a professional mechanic. Working on critical systems can be dangerous.

Problem Statement

Learn how to reset the EPS warning light on Honda Accord 9th Generation (2013-2017). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Steering

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical components to prevent short circuits.

Symptoms

•EPS warning light illuminated on the dashboard
•Difficulty steering the vehicle (heavy steering)
•Intermittent loss of power steering assistance
•Power steering system making unusual noises
•Check engine light may also be illuminated

Diagnostic Steps

1
Inspect the power steering fluid level and condition.
2
Check for any stored error codes using an OBD-II scanner.
3
Examine the power steering system for visible leaks or damaged components.
4
Verify battery voltage and condition, as low voltage can affect EPS function.
5
Test the EPS motor and steering angle sensor functionality.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Torque wrench

Parts Required

•Power steering fluid
•EPS fuse

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the power steering fluid level and condition.
2
Check for any stored error codes using an OBD-II scanner.
3
Examine the power steering system for visible leaks or damaged components.
4
Verify battery voltage and condition, as low voltage can affect EPS function.
5
Test the EPS motor and steering angle sensor functionality.

Solution

1. Preparation

Gather necessary tools and components.
Ensure the vehicle is parked on a level surface with the ignition off.
Disconnect the negative battery terminal for safety.

2. Check Power Steering Fluid

Locate the power steering fluid reservoir (usually near the engine).
Remove the cap and check the fluid level. It should be between the minimum and maximum marks.
If low, top off with the recommended power steering fluid (consult the owner's manual for specifications).

3. Check EPS Fuse

Locate the fuse box (refer to the owner's manual for the exact location).
Identify the EPS fuse and inspect it for continuity; replace it if blown.
Reinstall the fuse box cover securely.

4. Clear Error Codes

Reconnect the negative battery terminal.
Use an OBD-II scanner to clear any stored error codes related to the EPS system.
Follow the scanner instructions to erase codes.

5. Reset EPS Light

Start the engine and let it idle for a few minutes.
Turn the steering wheel fully to the left and then fully to the right several times to recalibrate the EPS system.
Check if the EPS warning light has turned off.