why does my GMC Sierra T1XX (2019-Present) make a clicking sound when turning?

GMC Sierra T1XX (2019-Present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

548 words

Problem Statement

Learn how to diagnose and fix clicking sound when turning in GMC Sierra T1XX. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical components.
•Ensure the vehicle is securely supported by jack stands before working underneath.

Symptoms

•Clicking sound when turning the steering wheel
•Noise may change with speed or steering angle
•Potential vibrations felt in the steering wheel
•Possible loss of power steering assist
•Unusual tire wear patterns (if prolonged)

Diagnostic Steps

1
Inspect the CV joints for signs of wear or damage.
2
Check the wheel bearings for play or roughness.
3
Examine the power steering fluid level and condition.
4
Test the steering system for any binding or unusual resistance.
5
Inspect suspension components for damages or loose parts.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Floor jack
•Jack stands
•Socket set
•Breaker bar
•Torque wrench
•Bearing puller

Parts Required

•CV joint assembly (if damaged)
•Wheel bearing (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a flat surface and the engine is off.
Disconnect the battery to prevent electrical shorts.

2. Inspect and Replace CV Joints

Raise the Vehicle
- Use a jack to lift the front of the vehicle and secure it with jack stands.
- Tools Required: Floor jack, jack stands.
Remove the Wheel
- Use a socket set to remove the lug nuts and take off the front wheel.
- Tools Required: Socket set, breaker bar.
Inspect the CV Joint
- Examine the CV joint boot for tears or leaks. If damaged, the joint may need replacement.
- Check for excessive play in the joint by manually twisting it.
Replace the CV Joint (if necessary)
- Remove the axle nut with a socket and breaker bar.
- Detach the CV joint from the hub by removing any retaining clips.
- Install the new CV joint by reversing the disassembly process, ensuring proper torque on the axle nut (typically around 150 ft-lbs).

3. Inspect and Replace Wheel Bearings

Check Wheel Bearing Play
- Spin the hub and listen for grinding or roughness.
- Tools Required: None for initial check.
Remove the Bearing Hub Assembly
- If noise is present, remove the wheel hub by unbolting the bearing assembly from the steering knuckle.
- Tools Required: Socket set, torque wrench.
Replace the Wheel Bearing
- Press out the old bearing and press in the new one using a bearing puller.
- Reassemble the hub and torque to manufacturer specifications (typically around 80-100 ft-lbs).