how to troubleshoot my Ford Explorer Sixth Generation (2020-present) traction control disabled?

Ford Explorer Sixth Generation (2020-present)

Error Codes

1-3 hours

Time

medium

Difficulty

medium

Severity

3 min read

443 words

Problem Statement

Learn how to troubleshoot and fix traction control issues in a 2020-present Ford Explorer. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Electrical

Estimated Time

1-3 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems
•Allow the vehicle to cool before inspecting the engine components

Symptoms

•Traction control warning light illuminated on the dashboard
•Check engine light illuminated
•Loss of traction during acceleration
•Unusual vehicle handling in slippery conditions
•Increased wheel spin during takeoff

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner
2
Inspect the wheel speed sensors for damage or dirt
3
Check the brake fluid level and condition
4
Examine the ABS module for faults or connectivity issues
5
Test the vehicle’s battery voltage and connections
6
Review the traction control system settings in the vehicle's menu

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Multimeter
•Socket set
•Screwdrivers

Parts Required

•Wheel speed sensor (if damaged)
•Brake fluid (if low)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner
2
Inspect the wheel speed sensors for damage or dirt
3
Check the brake fluid level and condition
4
Examine the ABS module for faults or connectivity issues
5
Test the vehicle’s battery voltage and connections
6
Review the traction control system settings in the vehicle's menu

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a level surface and the engine is off.
Disconnect the battery to prevent electrical shorts.

2. Inspect Wheel Speed Sensors

Locate the wheel speed sensors on each wheel hub.
Remove any dirt or debris around the sensors.
Check wiring for frays or disconnections.
Use a multimeter to test sensor resistance; replace if faulty.

3. Check ABS Module

Access the ABS module, typically located near the brake master cylinder.
Inspect for any visible damage or corrosion.
Use a scanner to check for ABS fault codes; clear codes and retest the system.

4. Inspect Brake Fluid Level

Open the hood and locate the brake fluid reservoir.
Check the fluid level; refill with the manufacturer-recommended brake fluid if low.
Inspect for leaks in the brake lines or hoses.

5. Battery Check

Use a multimeter to measure the battery voltage; it should be around 12.6 volts.
Tighten the battery terminals to ensure good connections.
If the battery is weak, consider replacing it.