how to reset the tire pressure light on Ford Explorer Sixth Generation (2020-present)

Ford Explorer Sixth Generation (2020-present)

Error Codes

0.5 hours

Time

medium

Difficulty

medium

Severity

3 min read

430 words

Problem Statement

Learn how to reset the tire pressure light on Ford Explorer (2020-present). Step-by-step guide with diagnostic procedures and tips for maintaining tire pressure.

Affected Component

Electrical

Estimated Time

0.5 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always check tire pressures when the tires are cold for accurate readings.

Symptoms

•Tire pressure warning light illuminated on the dashboard
•Possible fluctuation in tire pressure readings
•Warning chime sounding intermittently when driving
•Tires may appear visually low on air
•No other warning lights present on the dashboard

Diagnostic Steps

1
Check all tire pressures using a tire gauge to ensure they are within the manufacturer's specified range.
2
Inspect each tire for visible damage or punctures.
3
Verify that the tire pressure monitoring system (TPMS) sensor is functioning by using an OBD-II scanner to check for any stored fault codes.
4
Confirm that the vehicle's settings allow for TPMS reset; consult the owner's manual if necessary.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•OBD-II scanner

Parts Required

•Tire pressure monitoring sensors (if faulty)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check all tire pressures using a tire gauge to ensure they are within the manufacturer's specified range.
2
Inspect each tire for visible damage or punctures.
3
Verify that the tire pressure monitoring system (TPMS) sensor is functioning by using an OBD-II scanner to check for any stored fault codes.
4
Confirm that the vehicle's settings allow for TPMS reset; consult the owner's manual if necessary.

Solution

1. Preparation

Ensure the vehicle is parked on a level surface.
Turn the ignition to the "On" position without starting the engine.

2. Check Tire Pressures

Use a tire pressure gauge to check the pressure in all four tires.
Inflate any tires that are below the recommended pressure to the correct PSI as specified on the driver's door jamb sticker.

3. Reset the Tire Pressure Monitoring System

Locate the TPMS reset button, usually found beneath the steering wheel or in the glove compartment.
Press and hold the TPMS reset button until the tire pressure light blinks three times, then release the button.
Start the vehicle and allow it to run for a few minutes to ensure the system calibrates.

4. Verification of Tire Pressure Light

Turn off the engine and then restart it to check if the tire pressure light remains off.
Drive the vehicle for a short distance to ensure the system has registered the new tire pressures.