how to reset the tire pressure light on Ford Explorer Sixth Generation (2020-present)

Ford Explorer Sixth Generation (2020-present)

Error Codes

30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

433 words

Problem Statement

Learn how to reset the tire pressure light on a 2020-present Ford Explorer. Step-by-step guide with diagnostic procedures and safety tips.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is on a flat surface when checking tire pressure.
•Always follow safety procedures when working near the vehicle's tires.

Symptoms

•Tire pressure warning light illuminated on the dashboard
•Possible fluctuating tire pressure readings on the display
•Noticeable under-inflation or over-inflation of tires when checked manually
•Reduced fuel efficiency due to improper tire pressure
•Vehicle handling issues such as pulling to one side

Diagnostic Steps

1
Check each tire’s pressure with a tire pressure gauge to confirm they are within the recommended range.
2
Inspect tires visually for any visible damage or wear that may affect pressure.
3
Verify that the spare tire (if equipped with a TPMS sensor) is also properly inflated.
4
Examine the vehicle's owner's manual for the recommended tire pressure values.
5
Confirm that the tire pressure monitoring system (TPMS) is functioning correctly by scanning for error codes if necessary.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•TPMS reset tool (if applicable)

Parts Required

•None specifically required for the reset, but consider replacement TPMS sensors if faulty.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Symptoms

•Tire pressure warning light illuminated on the dashboard

•Possible fluctuating tire pressure readings on the display

•Noticeable under-inflation or over-inflation of tires when checked manually

•Reduced fuel efficiency due to improper tire pressure

•Vehicle handling issues such as pulling to one side

Diagnostic Steps

1
Check each tire’s pressure with a tire pressure gauge to confirm they are within the recommended range.
2
Inspect tires visually for any visible damage or wear that may affect pressure.
3
Verify that the spare tire (if equipped with a TPMS sensor) is also properly inflated.
4
Examine the vehicle's owner's manual for the recommended tire pressure values.
5
Confirm that the tire pressure monitoring system (TPMS) is functioning correctly by scanning for error codes if necessary.

Solution

1. Preparation

Ensure that all tires are properly inflated to the manufacturer's recommended pressure.
Turn the vehicle's ignition to the "On" position without starting the engine.

2. Resetting the Tire Pressure Monitoring System

Locate the TPMS reset button, which is typically found under the steering column or near the driver's side door.
Press and hold the TPMS reset button until the tire pressure light blinks three times, then release the button.
Start the engine and allow it to run for a few minutes.

3. Finalizing the Reset

Turn off the engine.
Drive the vehicle at speeds above 50 mph for a few minutes to allow the TPMS to recalibrate.
Check to see if the tire pressure warning light remains off.