how to reset the check engine light on Ford Explorer Sixth Generation (2020-present)

Ford Explorer Sixth Generation (2020-present)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

354 words

Problem Statement

Learn how to reset the check engine light on a 2020-present Ford Explorer. Step-by-step guide with diagnostic steps and safety tips.

Affected Component

Engine

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is turned off before connecting or disconnecting the OBD-II scanner.

Symptoms

•Check engine light illuminated
•Engine running smoothly after repairs
•No pending error codes after diagnostic

Diagnostic Steps

1
Use an OBD-II scanner to check for any stored error codes.
2
Address any issues indicated by the error codes before attempting to reset the light.
3
If no issues are found, proceed to reset the check engine light.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Vehicle owner's manual

Parts Required

•None required for the reset procedure.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools: OBD-II scanner, vehicle owner's manual.
Ensure the vehicle is parked on a flat surface and the engine is turned off.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard, usually near the driver's seat.
Plug the OBD-II scanner into the port.

3. Read Codes (Optional)

Turn on the ignition to the "On" position without starting the engine.
Follow the scanner prompts to read any stored error codes if not already done.

4. Reset Check Engine Light

Navigate to the reset or erase function on the OBD-II scanner.
Confirm the reset command when prompted by the scanner.

5. Disconnect Scanner

Once the light is reset, safely disconnect the OBD-II scanner from the port.

6. Test Drive

Start the vehicle and take it for a short test drive to ensure the check engine light remains off.